• Keine Ergebnisse gefunden

Produces single or multiple paper copies of

N/A
N/A
Protected

Academic year: 2022

Aktie "Produces single or multiple paper copies of "

Copied!
2
0
0

Wird geladen.... (Jetzt Volltext ansehen)

Volltext

(1)

~.c:;] :I 4 Q C

I

Produces single or multiple paper copies of

high quality from microfilm output of S-C Recorders

The SOC 3400 is Micromation-designed to pro

-

duce the necessary paper copies of any data recorded on microfilm by So C Recorders. Com

-

pletely self

-contained,

it generates highly legible paper copies at the rate of 60 ft. per minute. Synchronous processing produces the

document s at the point of output in less than

30 seconds after exposure. The number of cop-

ies

,

single or multiple, is operator selected. The

speed

, flexibility and high quality of the copies

produced make the SoC 3400 particularly use-

ful wherever the demand for copies is high.

(2)

SoC 3400 CHARACTERISTICS

Hard Copy Output: Finished paper bearing an electro- statically formed image, permanently set and suitable for further processing_

Film Input: Non-sprocketed 16 mm microfilm_

Paper Input: Paper input may be in rolled form or fanfolded configuration; a range of paper format widths may be used in the SoC 3400_

Processing: Synchronous processing produces copies at the point of output in less than 30 seconds after exposure.

Processing Rate: Hard copy may be generated at the rate of 60 ft. per minute based on synchronous operation.

Paper Output: May be rolled, stacked or refolded where fanfolding format is used.

Operator Control: Single or multicopy output may be selected by operator.

Finished Copy' Since each copy, single or in multiples, is generated from the microfilm image, each one has

Printed in U.S.A.

uniform quality and readability. Since business forms may be superimposed over data in the recording process, finished copies may carry forms as well as computer-generated data.

Power: Operates from 208 or 230 VAC, single phase, 60 cycle ± 1

Y2

cps or 208 VAC, 3 phase 60 cycle

± 1/2 cps. Requires approximately 3000 watts input power.

Operating Temperature: 60°F to gO°F.

Relative Humidity: 20% to 80%.

Dimensions' 66" high, 66" wide, 28" deep.

~t ql1Jb~rg-CorlsD

Data Products Division, P.O. Box 2449. San Diego, California 92112

C31/11-66/10M

Referenzen

ÄHNLICHE DOKUMENTE

The COST Action TU1201 Urban Allotment Gardens in European Cities and the University of Applied Sciences and Arts Northwestern Switzerland (FHNW) invite participants to

Address. The DMA interrupt enable bit must be cleared in the Interrupt Mask Register for the interrupt to be recognized. This bit will remain active and must

The Data Read is delayed from Data Write and may be shifted into an external register by using the negative-going edge of the Data Read Shift Clocks or the

With a parallel printer port, three serial ports (one standard and two optional), and a game port, the Magic I/O packs more features and connectors on a true

Load the correct paper size, or change the paper size setting, then open the Duplex Unit cover and remove any jammed paper.. Close the cover of the Duplex Unit, and the printer

Input port lines and output port lines are accessed at 16-pin DIP sockets on the card.. A reset line is

It signals the central control or the processor (depending on the Medium Data Processing System) to au- tomatically translate EBCDIC to BCL informa- tion as it is

signal on this line indicates that the external equipment has accepted the word of information and will turn off the output data ready signal at the com- puter; this causes