Spinner CNC turningcenter

In this work the main goals are the construction an autofocus fluid lens device to investigate membrane actuators based on actuator material such as conductive polymers and ionic

The main joint of the skeleton for the action detection is neck and if the OpenPose algorithm can not detect the human neck, the whole skeleton will not be predicted on the

The goal of this thesis is to test memory optimization and reclamation tools in VMware ESXi, Microsoft Hyper-V, KVM, and Xen — measure how much memory can hypervisors reclaim from

PPyTF-fiber-40ks and PPyTF-film-40ks are investigated under isometric ECMD measurements in PC-TF electrolyte at applied potential between 0.65V to -0.5V square wave potentials

On-board computer system’s electronics board features a pin header (Figure 4.23) that is used to connect with attitude and orbit control system’s sensor board (Figure 4.33)..

Keywords: histogram equalization, face detection, face alignment, label distributed encoding, local phase quantization, neural network, convolutional neural network, deep learning,

In this chapter, first, the proposed global motion planning algorithm for object transportation is presented and subsequently, a ROS local planner plugin is introduced that can take

The critical electric field values for massive surface deformation in the case of constant surface electric field and spatially varying electric were found to be 24.6 GV m and 21.5 GV